FOREWORD
This Indian Standard IS 16103 (Part 2) was adopted by the Bureau of Indian Standards, after the draft finalized by the Electric Lamps and Their Auxiliaries Sectional Committee had been approved by the Electrotechnical Division Council.
This standard IS 16103 (Part 2) specifies the performance requirements for LED modules for general lighting services. The other part in the series is:
Part 1 Safety requirements
This standard IS 16103 (Part 2) covers the performance requirements for LED modules for general lighting applications andacknowledges the need for relevant tests for this new source of electrical light, sometimes called ‘solid state lighting’.
The standard IS 16103 (Part 2) is seen in close context with simultaneously developed performance standard for luminaires in general and for LED luminaires. Changes in the LED module standard shall have impact on the luminaire standards and vice versa, due to the behaviour of LED. Therefore, in the development of the present standard, mutual consultancy of experts of both products has taken place.
The provisions in this standard represent the technical knowledge of experts from the fields of the semiconductor (LED chip) industry and of those of the traditional electrical light sources.
LISUN supplies the fully test solutions for the following IS 16103(Part 2): 2012, please see the below excel table:
IS 16103(Part 2): 2012 Clause and Subject | LISUN Model |
Clause 3.3-3.11 Lumen Maintenance | LEDLM-84PL |
Clause 6.1 Rated Life Time Up to a Maximum of 6000 h. | |
Clause 10.2-10.3 Lumen Maintenance | |
Clause 3.22 Luminous Flux | LPCE-2(LMS-9000) |
Clause 8.1 Luminous Flux | |
Clause 8.3 Efficacy | |
Clause 8.2 Luminous Intensity Distribution, Peak Intensity and Beam Angle | LSG-1890B |
Clause 9 CCT and Colour Rendering | LMS-6000 |
Clause 13 Test For Emission (Radiated And Cobducted) |
EMI-9KB |
Your email address will not be published. Required fields are marked *
[wpforms id="9600"]